Engineering Center

Looking to use speed sleeves in hospital, can different cables be passed through the same sleeve?

I want to have a short report to be created, but I forgot how to set a short report. Thank you.

I have prefabricated balustrade to install. Each stanchion baseplates have two 200mm long 20mm rods to be epoxied. I need to drill the holes bigger to have installation play and accommodate fabrication and drilling errors. I am looking for a product allowing to drill the holes bigger. As big as possible. Please see attached f...

On page 689 of Hilti Anchor fastening technology manual version 2023, for Hilti HSC-I Concrete Anchors, lists recommended tensile and shear loadings based on 25MPa concrete. On this project the concrete has a tensile strength of 40MPa. Can the recommended tensile and shear loadings for Hilti HSC-I Concrete Anchors be increased...

Is there an appropriate anchor to fix props to a reinforced concrete masonry wall to temporary prop a precast panel from? i.e. an anchor where an increase in load will result in an increasing wedging force, which has design capacities when anchored in concrete masonry? Concrete masonry is reinforced, solid filled 200 series b...

Hi HILTI, I have project which I'm going to connect The beam and deck to existing column. In my 3D design ( ETABS ) it has Mz bending - moment and I cant see it effects on my rebar profis (input). please help me

Hello! I've received an email from Hilti confirming my access to Profis Engineering Premium Suite, but I cannot figure out how to get to Profis Premium. Links in the email and all login options takes me to the free version with an offer to upgrade. Also; is Profis Engineering Premium available as an application or just via ...

Is there a Hilti seismic anchor that is applicable to a 100mm thick slab?

Hi, I wanted to enquire about the default settings for a seismic C2 anchor design check on PROFIS. I believe the design method should be EN 1992 as it seems to supersede ETAG. However, a bit unsure about seismic displacement type setting. Default settings choose EN1992-4. Are you able to provide an explanation to the differen...

Can I use expanding foam to fill small void to prevent the chemical from falling through the hole. The slab is 100mm thick and was drilling 90mm deep for an m20 stud... Some holes have drilled through the slab.