Home
Products
Direct Fastening
Threaded studs
Sharp-tip Threaded Studs

Sharp-tip Threaded Studs

Show me sharp-tip threaded stud pins for fastening to concrete, masonry and steel

An error occurred

Unfortunately, products matching your chosen category can not be loaded, due to technical issues. Please try again later. Thank you for your understanding.

No products matching your requirements

Unfortunately, there are no products matching your requirements. Please update or reset your applied filters.

X-M6 D12

Ultimate

Threaded stud (for 12mm washer)

Base materials: Concrete (soft)
Corrosion protection: Zinc-coated 5-13 µm
Environmental conditions: Dry indoor

From NZD420.00

Compare (1)

X-M10 P10

Ultimate

Carbon steel threaded stud for use with powder-actuated nailers on concrete (10 mm washer)

Base materials: Concrete (soft), Concrete (tough)
Corrosion protection: Galvanised zinc coated <20 µm
Environmental conditions: Dry indoor

NZD163.00

Compare (1)

X-EM10H P10

Premium

M10 threaded stud (with 10 mm plastic washer)

Base materials: Steel
Minimum thickness of base material (steel): 6 mm
Corrosion protection: Galvanised zinc coated <20 µm

NZD145.00

Compare (1)

X-ST-GR M8

Premium

Threaded stud (for steel, with 8 mm washer)

Base materials: Steel
Minimum thickness of base material (steel): 6 mm
Corrosion protection: Stainless steel A4(316) or equivalent

NZD694.50

Compare (1)

Back to products ()

Compare

Products ()

Added to cart

Go to shopping cart

Update of quantity

Please note, the order volume has been updated. This is due to package and minimum order quantities.

Please note, the order volume has been updated to . This is due to package and minimum order quantities.

Hilti = registered trademark of Hilti Corporation, 9494 Schaan, Liechtenstein
© 2009-2016, Right of technical and program changes reserved, S.E. & O.

Hilti New Zealand
Customer Services: 0800-444-584