HOW SAFESET IMPROVES REBAR INSTALLATIONS

Fully approved, safer and more productive installations at your jobsite

SafeSet system for installing rebar connections with HIT-RE 500 V3 epoxy mortar

SafeSet is our system for installing anchor fastenings.

SafeSet helps to ensure that anchors can carry their maximum load values safely, minimising the risk of failing anchors.

It’s designed to speed up the installation of anchors and rebar connections and to make them safer and more reliable.

All the components of SafeSet are covered by international approvals and fit seamlessly together.

SafeSet is the Hilti system for setting anchors and post-installed rebar connections.
SafeSet helps ensure that anchors can carry their maximum load values safely, minimising the risk of anchor failure. It’s designed to speed up the installation of anchors and rebar connections and to make them safer and more reliable. 
All SafeSet components are covered by international approvals and work seamlessly as a system.

Learn more about the SafeSet system here

ASK AN ENGINEER

HAMMER-DRILLED HOLES

AUTOMATIC CLEANING

Eliminate extra steps with our hollow drill bits

Clean holes as you drill with our TE-CD (SDS Plus) or TE-YD (SDS Max) hollow drill bits connected to the VC 20/40 concrete dust vacuum system and eliminate six manual steps as the dust is then removed automatically.

Just drill the hole, inject the adhesive and set the anchor.

SafeSet Method vs. Traditional Method

Automatic cleaning with our hollow drill-bit

Automatic cleaning with our hollow drill-bit

DIAMOND-DRILLED HOLEs

Save time and achieve a better bond

Raise bond strength with our roughening tool

The Hilti TE-YRT roughening tool is designed to roughen a diamond-drilled hole in order to achieve the necessary bond between the epoxy and the concrete.

It raises the bond strength in diamond-cored holes up to that of hammer-drilled holes and reduces the amplification factor of the minimum anchorage length required by Eurocode 2 to 1.0

The roughening tool combined with HIT-RE 500 V3 achieves a time saving of 30% with core-drilled holes by reducing the need for cleaning.

 

Diamond-cored hole with and without roughening

From coring to installation

SafeSet system

Simple, safer and more reliable way to install anchors and post-installed rebar. Irrespective of your preferred drilling technique, we have the right SafeSet solution for you

Find out more

ANCHOR SOLUTIONS

SafeSet makes anchor installation safer and more productive

Find out more

Hilti PROFIS SOFTWARE

Design safer, reliable anchor systems more efficiently than ever

Find out more

Start benefitting from SafeSet

Share via: